CG – Aluminum Mill Hole Pattern “D” Bottom Mount SurfaceMate Square Base Shoe

#CG1001

$290.00 $250.00

Out of stock

CG – Aluminum Mill Hole Pattern “D” Bottom Mount SurfaceMate Square Base Shoe

#CG1001

  • Adjustable Angle Base Shoe and Shimming System for Dry Glazing 1/2" (12 mm) Monolithic Tempered Glass
  • Drilled and Counter Bored 12" (305 mm) Center-to-Center, or We Will Custom Drill to Your Specifications
  • Custom Cutting and Mitering Service Available
  • 6063 Alloy - T52 Temper
This CG - Hardware  Square Base Shoe is used as the base channel for glass railing systems. It can be clad in several choices of architectural finishes. The most critical component in a railing system is the proper attachment of the base shoe to the substrate. CG - Hardware has engineered and tested a variety of attachment methods, and has developed an acceptable combination of drilling patterns and fasteners. Important Notes: CG - Hardware does not recommend direct powder coating of this base shoe extrusion. Powder coated cladding applied over the base shoe is the recommended method. All pre-drilled CG Hardware Base Shoes have a +1/8 (3mm) / -1/16 (1.5mm) tolerance between each hole drilled in the base. Before drilling installation holes in the concrete or steel substrate it is recommended that the installer place the base shoe into the planned final position, then mark the position of the holes to be drilled into the substrate.

Most useful reviews

There are no reviews yet.

Be the first to review “CG – Aluminum Mill Hole Pattern “D” Bottom Mount SurfaceMate Square Base Shoe”

Your email address will not be published. Required fields are marked *

CG - Aluminum Mill Hole Pattern "D" Bottom Mount SurfaceMate Square Base Shoe

#CG1001